Vivitar Vivicam T027 Power Button Replacement

Written By: Dana
  • Comments: 0
Vivitar Vivicam T027 Power Button Replacement

Difficulty

Difficult

Steps

5

Time Required

15 - 30 minutes

Introduction

If the power button on your Vivitar Vivicam T027 digital camera breaks or gets jammed, you may need to replace it. This guide will show you how.

Note: This repair requires soldering. View the soldering guide for more information.

  1. 1JXuIljXmuuWPmfp
    1JXuIljXmuuWPmfp
    PjEDQBeiNbvHANKr

    • Using a Phillips #00 screwdriver, remove four exposed 3mm screws.

    • You will find one screw on the top, one on the bottom, and one on each side of the camera.

    • Put the screws in a safe place so you can find them and put them back in later.

  2. gLoUIvEJ23vGq2Nu

    • Remove the sticker on the top of the camera.

    • Use the Phillips #00 screwdriver to remove the screw that was underneath the sticker.

  3. PUZRIXMVdonucKLP
    PUZRIXMVdonucKLP
    EwGZ3WBSXf1Ax4ax

    • Separate the front and the back of the camera completely to expose the motherboard.

  4. deW3kKKWiGWGnHHZ

    • Locate the power button on the top of the camera.

    • Using tweezers, gently remove the black plastic cover from the power button.

  5. jiuQfOVRY4rjiNPY
    jiuQfOVRY4rjiNPY
    PFeXNkGxX1BOyFEx

    • Using a soldering kit, de-solder the black and red wire from the silver power button.

    • Solder the new power button to the black and red wire.

    • To avoid burns, be careful of the heat from the soldering iron.

    • Reference the soldering guide for assistance!

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Dana

Member since: 11/03/15

110 Reputation

0 comments