Repairing an FJ-3LED Globe Electric Push Light

Written By: Rojina Saberi
  • Comments: 0
Repairing an FJ-3LED Globe Electric Push Light

Difficulty

Difficult

Steps

6

Time Required

15 - 30 minutes

Introduction

If your light has gone out and you’ve already changed the battery, the board may have some issues. This guide will show you how to fix circuit problems on an FJ-3LED Globe Electric Push Light which is popular among people for use in attics, basements, closets, cold rooms, cupboards, or storage sheds.

Soldering is required for this guide. If you are unfamiliar or need a refresher, check out this article on How to Solder and Desolder Connections. Be careful when soldering as the iron is very hot and there is a potential to get burned.

  1. 4NOVWdFYWMoIvRqb
    4NOVWdFYWMoIvRqb
    jxKSHUfYVyRfBILD
    eLejFvPKqYiDkdgo

    • Lift the black lid off of the battery slot and remove the batteries.

  2. x3eWp6DhVM6goS1h
    x3eWp6DhVM6goS1h
    CAHnHoGwn11Ji2yb
    U6KAkxAg1SG4PojR

    • Use the Phillips #1 screwdriver to remove four 1.4 mm screws from the back of the light.

    • Take the black part out and separate it from the white case.

  3. NFGk3eYgrYFZCPio

    • Identify which part of the lamp is broken.

    • in this case, one of the connections in the circuit had been disconnected.

  4. KCP3EGaRUyFfYk6s

    • For tips on Soldering, see How to Solder and Desolder Connections.

    • Attach the disconnected wire to its joint using solder and iron tip. Place the tip of the soldering iron against the solder pad.

    • Melt enough solder onto the solder pad.

    • Remove both the solder and the soldering iron tip from the connection as soon as enough solder melts onto the pad.

    • Don't forget to use gloves.

  5. nGwDUdbpKgBVJGgO
    nGwDUdbpKgBVJGgO
    cKV44LHACHn23Cu4

    • Push the circuit into its place.

    • Click the button to see if the wires are connected .

  6. fbJHlmJ3Ll1VRJtq
    fbJHlmJ3Ll1VRJtq
    dGFuFiTUYyBXqHT5

    • If the lights turn on, the connection is perfect in the circuit and the disconnected joint is now connected.

    • Place the white case on top of the circuit and close it with the Phillips #1 screwdriver.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Rojina Saberi

Member since: 11/05/21

133 Reputation

0 comments