Nextbook Premium 7SE Volume Buttons Replacement

Written By: Michelle Helweh
  • Comments: 0
Nextbook Premium 7SE Volume Buttons Replacement

Difficulty

Difficult

Steps

9

Time Required

35 minutes

Introduction

It's important to note that replacing the volume buttons includes using three prerequisite guides.

  1. IrcQWTxERPosZSlt
    IrcQWTxERPosZSlt
    vkKA5sL6SLSkPITk
    35btdGJJFMj5EOes

    • Insert the plastic opening tool into the middle of the bottom edge of the device. The tool should be inserted within the seam between the back and front covers.

    • Slide the opening tool to the right and slowly continue to separate the back cover from the device.

    • Avoid prying on the buttons, as they are easily damaged.

  2. JCsdKRXWgajHRQKG

    • Pull the cover off of the device once about three quarters of the cover has been pried open using the plastic opening tool.

  3. iB6CoiVkUA4BEGFD

    • Remove masking tape from the battery.

  4. oUPHtv1nUv4tvWJS
    oUPHtv1nUv4tvWJS
    ovaBhl3KrgKlsVEv
    TNtFiuGwTXGJGVaQ

    • Pry the battery from the base using the nylon spudger and move it away from the motherboard.

    • Handle the battery with care to avoid damaging it.

  5. uFFPh5ig1SQyLp3d
    uFFPh5ig1SQyLp3d
    1GmvxCseEZTeRQBo
    XwuV2cOhspbF6qFR

    • De-solder the three contact points and remove the battery.

    • See the following guide for instructions on how to solder. How To Solder and Desolder Connections

    • Use caution when operating the soldering iron.

  6. DamSMHaX4R5ZKGQo
    DamSMHaX4R5ZKGQo
    W1PUNANoJJH1Y2oM
    mVrZAuUIYAGMfsCR

    • Remove the two ZIF connectors attached to the motherboard by flipping up the black tabs before pulling the ribbon cable away.

    • Only use a fingernail or nylon spudger to flip up the retaining flap. Using metal tools may damage delicate components.

  7. BMGWwQBN3utNPWEF

    • Use the nut driver and J00 bit to remove the three 4 mm screws.

  8. ZfNyJHbu61TgMFas
    ZfNyJHbu61TgMFas
    bgsUoWxUrGlOb4iB
    WYcvLAJVhLAUrlve

    • Peel back metal tape that is hiding the auxiliary port wires.

    • Remove tape that is holding the speaker wires in place.

    • Lift up on the motherboard to release it from the tablet.

  9. KXTvw2GfTYYqMFLy

    • De-solder volume buttons' eight contact points.

    • Each button has 4 points of contact.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Michelle Helweh

Member since: 31/10/16

214 Reputation

0 comments