NPET K10V3 Key Cap Replacement

Written By: Josh Cameron

Comments: 0

Difficulty

Very easy

Steps

Time Required

5 - 20 seconds

Introduction

This guide will show you how to replace the key caps on an NPET K10V3 keyboard. Over time, key caps can become worn, damaged, or clogged with debris. Removing a faulty key cap is a quick and easy process that requires little to no tools. Each key cap has a sleeve that connects into a housing to allow for proper contact of the membrane's corresponding pressure switches which sends the electric signal to the computer.

Special Requirements:

Use a key cap remover if too tight for hands. (optional)

Hazards:

Getting shocked if keyboard is not unplugged.

Tools

key cap remover

Step 1

Remove the keyboard from its power source.

Step 2

Firmly grasp the key that will be removed.
Remove the keycap by pulling directly upward.
Not pulling straight upward or securely will cause damage to the device.
If your fingers cannot get a good grip the key cap, use a key cap puller in the same orientation as with fingers.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Josh Cameron

Member since: 18/03/24

124 Reputation