MerchSource the Black Series Boat Racer Battery Cable Replacement

Written By: Monica Reece
  • Comments: 0
MerchSource the Black Series Boat Racer Battery Cable Replacement

Difficulty

Moderate

Steps

6

Time Required

10 minutes

Introduction

This repair guide will show you how to replace the cable that connects the positive battery terminal to the circuit board within the remote controller for the MerchSource the Black Boat Series Boat Racers Device.

  1. P6ElXD1rRJTjELvd
    P6ElXD1rRJTjELvd
    pUGUfllaZpVcO6MG

    • Turn the remote controller over to the back.

  2. YGQPhlOTk3aQtf6v

    • Slide the battery cover off.

  3. NjadkpLl5rEqOBxf
    NjadkpLl5rEqOBxf
    DGsoRqPgAYTlMJQY

    • Remove both AA-batteries.

  4. A5BSHiEOFAmxyF6g

    • Use a Phillips #1 screwdriver, remove the four screws located in the four corners of the back of the remote controller.

    • Screw length is 6 mm.

  5. d1NESQKPIW5vFBDG
    d1NESQKPIW5vFBDG
    FbNhXvfSAAfjYcsp
    RHfyT3OlO2daF2Ex

    • Separate the two halves of the remote controller.

  6. c4c1BaTeQNMX1oBU

    • Solder the wire to reconnect it.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Monica Reece

Member since: 31/08/18

672 Reputation

0 comments