Dyson Pure Cool AM11 Base Replacement

Written By: Gregory Crimmins

Comments: 1

Difficulty

Moderate

Steps

Time Required

5 minutes

Introduction

This Guide is to help you if you need to get access to the inside of your fan to fix wire the motor or other parts. We will walk you through the steps to safely open it up and put it back together.

Tools

Step 1

With the device flipped upside down, use a Phillips #1 screwdriver to remove the 4 screws holding the 3 tabs down.

Step 2

Remove all 3 tabs that you unscrewed.

Step 3

Using a Torx T20 Screwdriver, remove the screw in the center of the base.
Remove the two screws connected to the rotation arm.

There are instructions missing here. The black middle panel once removed gives access to two screws that are connected to the rotation arm (visible in the photo above), these need to be removed.

Alex Howarth - 29/04/24

Step 4

Lift the base of the housing from the rest of the fan.
Be careful not to pull too hard while lifting the lower body housing as there is wires that run throughout the housing that could be damaged if too much force is used.

Author

Gregory Crimmins

Member since: 01/11/23

109 Reputation