Terontola–Foligno railway
Overview
Status	in use
Owner	Rete Ferroviaria Italiana
Line number	106
Locale	Umbria, Tuscany, Italy
Termini	Terontola-Cortona Foligno
Service
Type	Heavy rail
Operator(s)	Trenitalia
History
Opened	21 July 1866
Technical
Line length	82 km (51 mi)
Number of tracks	1
Track gauge	1,435 mm (4 ft 8+1⁄2 in) standard gauge
Electrification	3 kV DC
Route map km elev from Florence 82.200 Terontola-Cortona 271 m to Rome Tuscany Umbria border 78.795 Borghetto di Tuoro 265 m RA6 74.762 Tuoro sul Trasimeno 267 m 70.207 Passignano sul Trasimeno 263 m 63.679 Torricella 260 m 63.103 Magione tunnel (1,301 m) 61.802 60.879 Magione 252 m 55.423 Monte Melino (1939[1]–1998) 229 m 49.616 Ellera-Corciano 256 m to Tavernelle (closed 1960) 46.326 Perugia Silvestrini (opened 2003[2]) RA6 43.763 Perugia Capitini (opened 2008[3]) 41.775 Perugia Università (opened 2003[2]) 39.580 Perugia 304 m RA6 32.765 Perugia Montebello (opened 1962[4]) 250 m FCU line from Sant'Anna FCU line from Terni 28.333 Perugia Ponte San Giovanni 208 m FCU line to Sansepolcro Tiber 24.438 Perugia Aeroporto (1939[5]–1939[6]) 24.438 Collestrada (1866–1930) 22.600 Ospedalicchio (opened 1939[7]) 200 m Chiascio 19.026 Bastia 203 m 15.639 Assisi 222 m 10.009 Cannara (closed 1995) 210 m 4.904 Spello 220 m Topino from Ancona 0.000 Foligno 239 m to Rome km Source: Italian railway atlas[8]

The Terontola–Foligno railway is an electrified, standard-gauge Italian railway that connects the Florence–Rome railway in Terontola-Cortona with the Rome–Ancona railway in Foligno, passing through Perugia and Assisi.

History

The railway was inaugurated in December 1866 as an integral section of the Florence–Foligno line, which was later merged with the Rome–Ancona railway, thus making journeys between Florence and Rome possible; this became more important after the conquest of Rome by Italy in 1870.

In 1875, with the opening of the Terontola–Chiusi section, which shortened the Florence–Rome route by several tens of kilometres, all the trains between these two destinations were diverted to the new railway; as a result the Terontola–Foligno was relegated to the role of secondary railway.

Starting in 1960, the railway underwent numerous modernisations: it was electrified, the equipment was replaced and the main station squares were rebuilt. However, the branch to Tavernelle (Panicale), which connected to the line at Ellera-Corciano station was closed due to low traffic.

Electric operations on the line commenced at the timetable change of May 1960.^[10]

Over time, the line has continued to play the role of connecting the Florence–Rome and the Rome–Ancona lines, frequented mostly by regional trains of various compositions and railcars of the Ferrovia Centrale Umbra, as well as by trains running directly between Perugia and Rome via Foligno. Travel times for the whole line range from 60 to 90 minutes. Doubling of the line was planned in 2011.

Route

The Terontola–Foligno line can be divided into three sections.

The first section, about 25 kilometers long, winds from the junction with the Florence-Rome to the exit from Ellera-Corciano station and is characterised by long straights and very wide curves. It begins in the Tuscan territory with a two-kilometre straight from Terontola station and, after a couple of short tunnels, turns south-east reaching Tuoro station; it continues alongside Lake Trasimeno, following its profile and passing by Montecolognola with the longest tunnel of the line, about 1.3 km long, and reaching Magione; it then runs to Ellera, including a long stretch on an embankment.

The second section, of about 18 km, starts from Ellera and continues to Ponte San Giovanni; it has the steepest grades of the line (around 1.0%) and the narrowest curves (although the curve radiuses are never less than 500 metres). There are also four tunnels and a masonry viaduct with five spans in the San Vetturino area. The railway winds around the Umbrian capital in a sinuous "S", shaped path, called the ansa di Perugia ("loop of Perugia"), which significantly extends travel times. At Ponte San Giovanni, the line crosses the Terni–Perugia–Sansepolcro railway, which runs through the entire Tiber valley in a north–south direction; a short branch (5.3 km) runs from the same station to Perugia Sant'Anna, near Perugia's historic centre.

The third section, about 28 km long, runs from Ponte San Giovanni to Foligno and is characterised by a totally flat area and an almost straight line, except for some bends near the towns. In this first part of the line, the main structures are a masonry bridge over the Tiber, immediately after Ponte San Giovanni station, a deep cutting in Collestrada, a metal bridge over the Chiascio and a masonry bridge over the Topino. Two stations on this last section of the line (Ospedalicchio and Cannara) have been closed due to a lack of traffic: the first has been disused since 1980, while the second closed in 1995. The facilities of the two stations still exist, but trains have not stopped there for some time.

References

External links

Media related to Terontola–Foligno railway at Wikimedia Commons