Delta III
A Delta III rocket diagram
FunctionOrbital launch vehicle
ManufacturerBoeing
(design, manufacturing and assembly)
Mitsubishi Heavy Industries
(extended kerosene tank and H-IIA-based upper stage manufacturing)
NASDA
(H-IIA/DCSS upper stage design)
Country of originUnited States
Size
Height35 m (115 ft)
Diameter4 m (13 ft)
Mass301,450 kg (664,580 lb)
Stages2
Capacity
Payload to LEO
Mass8,290 kg (18,280 lb)[1]
Payload to GTO
Mass3,810 kg (8,400 lb)[1]
Associated rockets
FamilyDelta
Launch history
StatusRetired
Launch sitesSLC-17B, Cape Canaveral
Total launches3
Success(es)0
Failure(s)2
Partial failure(s)1
First flightAugust 26, 1998
Last flightAugust 23, 2000
Boosters
No. boosters9 GEM 46
Maximum thrust628.3 kN (141,200 lbf)
Specific impulse273 seconds (2.68 km/s)
Burn time75 seconds
PropellantHTPB bound APCP
First stage
Powered by1 Rocketdyne RS-27A
Maximum thrust1,085.79 kN (244,100 lbf)
Specific impulse254 seconds (2.49 km/s)
Burn time260 seconds[2]
PropellantLOX/RP-1
Second stage
Powered by1 Pratt & Whitney RL10B
Maximum thrust110.03 kN (24,740 lbf)
Specific impulse462 seconds (4.53 km/s)[3]
Burn time700 seconds[2]
PropellantLOX/LH2
Third stage (Optional)
Powered by1 Thiokol Star 48B
Maximum thrust66.723 kN (15,000 lbf)
Specific impulse286 seconds (2.80 km/s)
Burn time87 seconds
PropellantHTPB

Delta III was an expendable launch vehicle made by McDonnell Douglas (later acquired by Boeing). The vehicle was developed from the highly-successful Delta II to help meet the launch demand of larger satellites. The first Delta III launch was on August 26, 1998.[4] Of its three flights, the first two were failures, and the third, though declared successful, reached the low end of its targeted orbit range and carried only a dummy (inert) payload. The Delta III could deliver up to 3,810 kg (8,400 lb) to geostationary transfer orbit, twice the payload of its predecessor, the Delta II.[1] Under the four-digit designation system from earlier Delta rockets, the Delta III is classified as the Delta 8930.

History

Due to the continual size and mass growth of commercial satellites in the late 1980s, McDonnell Douglas realized the need for a higher-performance rocket than even their new Delta II. New satellite bus offerings from Hughes required a launch vehicle with a 4-meter diameter payload fairing as well as the ability to send 3.5 tons of payload to a geostationary transfer orbit - neither of which Delta II offered.[5]

Multiple options for evolving the Delta II to support larger payloads, namely using higher-performing liquid hydrogen-liquid oxygen upper stages, were considered in the late 1980s and early 1990s. Eventually, the Delta III was announced in 1995, boasting an evolved Delta II first stage and a second stage based on that of the Japanese H-II rocket. This led to Delta III being similar in size to the Delta II, meaning that the existing Delta II infrastructure at SLC-17B could be used after some modifications. Soon after the announcement, Hughes placed an order for 13 Delta III launches.[5]

Delta III would only fly three times. The first two launches, both carrying live satellites, ended in failure. The third and final launch, carrying a dummy payload, was only partially successful after the RL-10B second-stage engine shut down prematurely. After commercial interest declined, the Delta III program was officially ended in 2003. Boeing then transitioned their focus to the new Delta IV rocket, which was much more capable than Delta III.[5]

Multiple Delta III rockets were already built and would have been unused, but they were cannibalized for parts for both Delta II and Delta IV.[5]

Description

Delta III was developed from the Delta II rocket. The new vehicle sported a modified first stage and a new, more efficient upper stage. This led to Delta III having around double the payload capacity of Delta II. However, the consecutive failures of the initial Delta IIIs, combined with the more advanced Delta IV program and the continuing success of the Delta II, left the Delta III as an interim vehicle.[3]

First stage

Like the Delta II, the first stage of the Delta III burned kerosene and liquid oxygen and was powered by one Rocketdyne RS-27A main engine with two vernier engines for roll control.[6] The vernier engines were also used for attitude control after the main engine shut off, just before the second stage separated.[2] While the propellant load and gross mass of the stage were nearly identical to the Delta II, the diameter of the kerosene tank was increased from 2.4 meters to 4 meters, while its height was reduced. The liquid oxygen tank and engine section remained largely unchanged. The redesigned kerosene tank reduced the overall length of the stage and, combined with the increased height of the second stage, allowed the Delta III to use the same launch facilities as the Delta II with only minor modifications.[1]

The first stage thrust was augmented by nine GEM-46 solid rocket boosters, sometimes referred to as GEM LDXL (Large Diameter Extended Length). These were 14.7 m (48 ft) meters in length, 1.2 m (46 inches) in diameter, and had a mass of 19 metric tons each, about six metric tons more than the Delta II's standard GEM-40 motors. Six were ignited on the launch pad, while the remaining three were ignited just before burnout and separation of the ground-lit boosters. To maintain steering authority, three of the ground-lit boosters had vectoring nozzles.[1] GEM-46 boosters would later find use on the Delta II, leading to the Delta II Heavy.

Delta Cryogenic Second Stage

A Delta III DCSS upper stage undergoing testing at Plum Brook Field Station in January 1998

The second stage of the Delta III was the newly developed Delta Cryogenic Second Stage (DCSS), which burned liquid hydrogen and liquid oxygen. It was developed and manufactured partly by Mitsubishi Heavy Industries and was based on the second stage of JAXA's H-IIA rocket. Boeing was in charge of preliminary design, and the development of new technologies (and the DCSS of which it was derived from the H-IIA's upper stage), while Mitsubishi Heavy Industries was responsible for manufacturing. The liquid hydrogen tank was 4 m (13 ft) meters in diameter, while the separate liquid oxygen tank (attached by a truss to the bottom of the hydrogen tank) was around 3 m (9.8 ft) meters in diameter. This stage offered significantly better performance than the Delta II's second stage, the Delta-K, which burned hypergolic propellants.[1] The DCSS was powered by a Pratt & Whitney RL10B-2 engine, derived from the RL10 powering the Centaur upper stage but featuring electromechanical actuators for gimbal control and an extending nozzle for increased specific impulse.[6] After Delta III's retirement, this stage design was modified for use as the Delta IV's second stage.[7]

Control of the second stage was provided by 4 sets of hydrazine thrusters installed around the bottom of the liquid oxygen tank. During engine burns, these thrusters only provided roll control (as the engine itself could gimbal for pitch and yaw). During coast periods, these would then provide 3-axis control.

Star 48B third stage

Delta III was offered with an optional third stage, the Star 48B solid rocket motor. It would have been attached on top of the DCSS and contained inside the payload fairing. The stage would have been used for high-energy orbits, like interplanetary missions.[2] It was never flown on Delta III but was commonly used on Delta II missions. It has also seen use on Delta IV and Atlas V.

Payload fairing

The payload fairing was a new composite design, matching the upper stage hydrogen tank's 4 m (13 ft) diameter and allowing larger payloads than the Delta II's 9.5 or 10-foot-diameter fairing. Delta III's 4-meter fairing was derived from Delta II's 10 ft composite fairing.[2] This fairing design would later be repurposed on the Delta IV Medium.

Launches

Flight Number Date / time (UTC) Rocket
Configuration		 Launch site Payload Payload mass Orbit Customer Launch
outcome
1 August 27, 1998
01:17		 Delta 3 8930 CCAFS SLC-17B Galaxy 10 1,543 pounds (700 kilograms) GTO PanAmSat / Intelsat Failure
Maiden flight of Delta 3 8930, Destroyed by range safety after control problems and depletion of hydraulic fluid, Communications satellite.
2 May 5, 1999
01:00		 Delta 3 8930 CCAFS SLC-17B Orion 3 9,480 pounds (4,300 kilograms) GTO Loral Failure[8]
Second stage engine failure. Payload placed in too low a LEO, Loral declared satellite lost. Communications satellite.
3 August 23, 2000
11:05		 Delta 3 8930 CCAFS SLC-17B DM-F3 9,663 pounds (4,383 kilograms) GTO US Air Force Partial failure[9]
Reached lower than planned orbit, final flight of Delta 3 8930, Demosat.

See also

References

  1. 1 2 3 4 5 6 "Delta III Launch Vehicle". 2001. Archived from the original on November 14, 2001.
  2. 1 2 3 4 5 "Delta III Payload Planner's Guide" (PDF). Archived from the original (PDF) on 19 November 2001.
  3. 1 2 "Delta III Data Sheet". Space Launch Report. Retrieved 26 July 2014.
  4. ↑ "Delta III Takes a Dip". Wired. Retrieved 2018-10-24.
  5. 1 2 3 4 Kyle, Ed. "Thunder Lost - The Delta 3 Story". spacelaunchreport.com. Archived from the original on March 21, 2022.
  6. 1 2 "Delta 3". Astronautix. Archived from the original on November 12, 2013. Retrieved January 5, 2015.
  7. ↑ "Delta 3 Rocket Falls Short, but Still a Success Boeing Says". SpaceFlightNow. August 24, 2000.
  8. ↑ "Orion 3 at 139° East (Launch failure)". Retrieved 7 September 2022.
  9. ↑ "Delta 3 rocket falls short but still a success, Boeing says". Spaceflight Now. August 24, 2000.

This article is issued from Wikipedia. The text is licensed under Creative Commons - Attribution - Sharealike. Additional terms may apply for the media files.