iFixit Adhesive Remover Preparation

Written By: Arthur Shi
  • Comments: 0
iFixit Adhesive Remover Preparation

Difficulty

Easy

Steps

2

Time Required

2 - 5 minutes

Introduction

This guide shows how to safely use iFixit’s adhesive remover.

  1. BjHlSrgMTHO2ZveZ
    BjHlSrgMTHO2ZveZ
    B62rCiTBAXbl2UrY

    • iFixit adhesive remover contains acetone, a mild skin and eye irritant.

    • Wear eye protection when handling and applying the adhesive remover. (Eye protection is included in your kit.)

    • Do not wear contact lenses without eye protection.

    • Protective gloves are also included in your kit. If you are concerned about possible skin irritation, put your gloves on now.

  2. PsQ3UElXRbheKGHw
    PsQ3UElXRbheKGHw
    hMMFDV1Dt3Eh4MTw
    e4aqIRIUyfGGdri2

    • Pull off the black rubber stopper from your bottle of adhesive remover.

    • Twist to loosen or remove the bottle cap before you cut the applicator tip.

    • This unseals the bottle and allows the pressure to equalize before you cut the applicator tip. If you skip this step, the adhesive remover may spray out unexpectedly when the tip is cut.

    • Use scissors to cut off the sealed tip of the applicator.

    • Cutting close to the narrow tip will give you better control so you can apply the adhesive remover in small amounts.

    • Twist and close the bottle cap securely before you proceed further.

Author

Arthur Shi

Member since: 03/01/18

263369 Reputation

0 comments