Introduction

This is a simple guide that will open up the car's insides and allow more access to the other parts of the car.

  1. FanxDDAiMhIR6uxn
    • Remove the four 3 mm screws from the bottom panel using a 3 mm Philips #1 screwdriver.

  2. Y2W2JxuPMYQRNiQb
    • Use the 3 mm Philips #1 screwdriver to remove the three 3 mm screws that connect the front panel with the main underside panel. Also remove the 6 mm front panel screw.

    • Remove the bottom panel by pulling the plastic tabs from either side of the car.

  3. NJRTJXyTsyYEQRHA
    NJRTJXyTsyYEQRHA
    LVZDiOeLQxfIakTa
    • Remove the two 6 mm screws and the two 3 mm screws that connect the back panel to the main underside panel.

    • Remove the two 6 mm screws that connect the rear panel to the body of the car.

  4. cPCgiFwNyXRCxB61
    cPCgiFwNyXRCxB61
    GAImlJUtTcJYRlPS
    NfUAThNwBlOEPm3u
    • Remove the two front 6 mm screws and the two middle 6 mm screws.

    • Remove the main underside panel carefully. Excessive force could damage or disconnect the fragile wires attached to this piece.

    • Remove the car shell and place it on the left side of the car.

Conclusion

To reassemble your device, follow these instructions in reverse order.

slcombs

Member since: 02/04/15

223 Reputation

0 comments