Introduction

If simple sensor maintenance fails to solve the problem with your dryer, replacement may be necessary. This guide details steps taken for replacement of the sensor board for the World Dryer Airforce J4-973A3.

  1. col4iwNEikjciED2
    col4iwNEikjciED2
    qZQrBE3PRnKYnrnD
    ybYU1mZFlJN3Ka1E
    • In order to change the air filter, start with the removal of the outer metal casing.

    • Using the special bit, remove the large screws at the bottom of the casing.

    • To remove the case, lift the indicated spot with your hands.

    • The direction for turning the screws is different than what was indicated on the small sticker above the hole.

  2. S511GjooMN6OAJMH
    S511GjooMN6OAJMH
    DO2ZapA2WEoEKiBq
    APA6tVOGrQUfMywf
    • Remove the 1/2" Ph1 screws at the bottom of the red fan cap.

    • Turn over the unit.

    • Push the red tabs on the back of the unit with medium to heavy pressure, using a plastic opening tool.

    • Carefully remove the cap, to prevent damage to the sensor.

  3. JOl5q56YUQXAsNQ2
    JOl5q56YUQXAsNQ2
    kliXTulXAHf6YGZ2
    • Remove both 3/8" Ph2 screws attached to the grey belt at the top and bottom.

    • Lift the grey belt away. This gives access to the server board.

  4. 4CKHs1BdCqWMMrQm
    4CKHs1BdCqWMMrQm
    j6QLAvvPdtIPErE6
    WBvxNOZRduULYZvj
    • Remove the rainbow ribbon cable from the middle circuit board, using a plastic opening tool.

    • Remove the 1/2" Ph1 screw from the center of the circuit board.

  5. EYGXNtreTDPMNeCA
    • Carefully remove the sensor board from your device.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Luke Clancy

Member since: 17/09/18

123 Reputation

0 comments