Introduction

If your toast rack does not slide up all the way, or your toast pops up too fast, try replacing the slide assist plunger with this guide.

  1. WjxUUa2puHV2SkLu
    • Using a wedge, pry off the rubber pieces on the bottom of each foot of the toaster.

  2. TVvter1lgkcGRkST
    • Remove the eight 8mm screws on each toaster foot using a Tri-point Y1 screwdriver.

  3. mrTcFbxsea1OdZD4
    • Remove the crumb collector located on the bottom of the toaster.

  4. qgSBOXNkgwPiJakp
    • Remove the three 8mm screws using the Tri-point Y1 screwdriver.

  5. 24LJFpjpfkVgyRCp
    • Remove the two 8mm screws on the bottom of the slide lever using a Tri-point Y1 screwdriver.

    • Once the screws are removed, detach the black plastic cover on the bottom of the slide lever.

  6. nP4BKrrMjKFEhHmS
    • Remove the final 8mm screw in the slide lever.

    • The lever can now pull away from the entire unit.

  7. 62wUiSShXki1KVMn
    • Remove toaster's outer shell by lifting straight up.

    • Slowly remove the outer shell. Disconnect ground wire before fully separating the shell and inner components.

  8. RHF4pxl3IPFxXWvd
    RHF4pxl3IPFxXWvd
    HAXUryJKeMAYK2p1
    • Disconnect the wire cluster that connects the lights and circuit board by pulling apart the two plastic connectors.

    • Remove the outer shell from the device.

  9. miuxhWYBOUfujWNd
    • Remove the top panel by bending the tabs on each side straight up.

  10. jBEqYNEqWpFe1LtR
    • Remove the two 8mm screws on the bottom of the plunger using a Tri-point Y1 screwdriver.

  11. wsMIKXAjhdyuaSPV
    wsMIKXAjhdyuaSPV
    CLuIBkaXRLpGvbWo
    • Remove the plunger from the device.

    I need two plungers

    Mattress1* -

    I need two plunger

    Mattress1* -

Conclusion

To reassemble your device, follow these instructions in reverse order.

Ryan Funchess

Member since: 19/04/18

715 Reputation

4 comments

Where does one get a new plunger for the replacement?

hsernaker -

yes, where does one get a new pludger?

hiyar124 -

Has anyone found a source for the WOLF toaster plunger?

Rick Guest -

Any pointers on where to find Wolf replacement parts ?

Stefano Concina -