Introduction
If your device is not working due to a problem with your power cord this guide will allow you to replace it to fix your problem.
-
-
Unscrew the 12 mm Phillips head screws located at the top of the cover and at the bottom two corners, using a Phillips #1 Screwdriver.
-
-
-
Unscrew the black 5.556 mm Phillip head screw on the power switch, closest to the power cord with a Phillips #0 Screwdriver.
-
-
-
Remove the white wire connected to the power cord and the motor by grabbing the white wire firmly on both sides near the motor mounting and wiggling until release.
-
Conclusion
To reassemble your device, follow these instructions in reverse order.
