Wacker Pump PT3A 2012 Recoil Starter Replacement

Written By: Arthur Shi
  • Comments: 0
Wacker Pump PT3A 2012 Recoil Starter Replacement

Difficulty

Moderate

Steps

3

Time Required

5 - 10 minutes

Introduction

This guide shows how to remove and replace the recoil starter for the Wacker Pump PT3A 2012.

  1. ioWeYCppLNNiKIMV
    ioWeYCppLNNiKIMV
    mnuENuLrJguFRrlY

    • Before you begin, make sure the device is switched off and the engine is cool to the touch.

    • Grab the plastic housing at the end of the spark plug wire.

    • Pull firmly to disconnect the wire from the spark plug.

  2. RESVYyU6UYedvtci

    • Use a 10 mm socket and wrench to remove the three bolts securing the recoil starter.

  3. yAYRuqiEiZhuCMWZ
    yAYRuqiEiZhuCMWZ
    a2XbRKjDWDmO3qjy

    • Remove the recoil starter from the engine.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Arthur Shi

Member since: 03/01/18

263396 Reputation

0 comments