Introduction

In this guide it is not necessary to replace the motor but you do need to move it out of the way to reach the switch.

  1. GSPE2I3cRKELOkOk
    GSPE2I3cRKELOkOk
    BGlFtkBJbLPeVyHR
    • There are two screws that require a 4.0mm flat head screwdriver. Twist them counter clockwise to remove. When you remove them they stay contained within the blue outer case.

  2. nmWvVEyZQnNfHdne
    nmWvVEyZQnNfHdne
    etKPStE36FOI4Lyb
    dMHbeMwewO1vFPgu
    • Pry the batteries out with your finger. When you replace them be sure to orient them correctly according to the markings in the slots. Match the plus symbol on the battery to the plus symbol in the slot.

  3. qAOMXnGrKjAWbwvS
    qAOMXnGrKjAWbwvS
    YbHLGthoToy143hX
    jXlDp5Bi34sRsM2Q
    • Remove 6 screws in order to pop off the outer shell and reach the inside components.

  4. wrkIblqKywfYP6XU
    wrkIblqKywfYP6XU
    TAR1lSm6AvE1BN2v
    G6ZKHmtcdUllILOY
    • Remove the motor by lifting it out of the shell, and find the attached wires at both ends: the circuit board and the motor itself. Use the soldering iron to remove the existing attachments by heating the solder joint with the solder iron tip while pulling on the wire.

    • Make sure the motor is aligned over the correct holes during reassembly.

  5. ScOFyDSfOMAJTXPR
    • Unscrew the two screws to the power switch located beside the circuit board

  6. Py5TueXUoQptGqXZ
    Py5TueXUoQptGqXZ
    WBQbyBHGVL3rAVtX
    S25EF1IRU1PxtwKH
    • Remove the existing attachments at both ends of the wires with the soldering iron. Heat the solder joint with the solder iron tip and pull the wire.

Conclusion

To reassemble your device, follow these instructions in reverse order.

William Jones

Member since: 04/09/15

222 Reputation

0 comments