Visioneer OneTouch 7400 USB Scanner Bed Replacement

Written By: Jena
  • Comments: 0
Visioneer OneTouch 7400 USB Scanner Bed Replacement

Difficulty

Moderate

Steps

6

Time Required

30 - 35 minutes

Introduction

Use this guide to remove the glass in the scanner bed in order to replace it.

  1. wacMvnq3SgXpChcV

    • On the bottom of the scanner, remove the screw at the top left side.

  2. B2koKhbUHvQBPMBM
    B2koKhbUHvQBPMBM
    RWX3IEXKFIP6Qn1Z

    • Remove the rubber foot pad opposite the screw hole to expose a second screw hole.

    • Remove the screw beneath the foot-pad.

  3. sPjZo5DlcpW5FoFZ
    sPjZo5DlcpW5FoFZ
    vqAmJdCK1fQNPFXS
    boukyuRvI3R6SR5T

    • Rotate the scanner so the screw hole is located on the top left hand side.

    • Place the plastic opening tool between the top casement and bottom casement of scanner with the hook facing up.

    • Gently pry the two casements apart beginning above the screw hole and working your way around.

    • Note that the top and bottom casings are held together by a series of 6 tabs. There is one tab on each of the long sides of the scanner approximately 6 inches in from the corners. There are two tabs on each of the short sides of the scanner approximately 2.3 inches in from the corners. Use the spudger to unhook the tab from the top casement.

  4. 55VsvkMdkqIlHXoR

    • Separate the two casement pieces.

  5. KVwHtgWLVhDpwiXM

    • Apply even pressure against the back of the glass while securing the plastic frame in place.

  6. fGyIn3IinvcNJOWp
    fGyIn3IinvcNJOWp
    wFh6aVklwgyKLlHO

    • With consistent pressure on the glass, move your fingers down the sides until the glass is no longer stuck to the double-sided tape.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Jena

Member since: 18/10/13

608 Reputation

0 comments