Trio Stealth G2 Hype Speakers Replacement

Written By: Thomas Lichtenberger
  • Comments: 2
Trio Stealth G2 Hype Speakers Replacement

Difficulty

Moderate

Steps

5

Time Required

2 minutes

Introduction

  1. VMNN1qhNQvcXVDMb
    VMNN1qhNQvcXVDMb
    jygNZTQHcAnXmDLX

    • Remove the two 1.2 mm Phillips #0 screws found at the side by the power button.

  2. LXmBlUjmNnLSLTvB

    • Using the plastic opening tool, insert it between the back panel and screen starting on the corner to the right of the power button side and begin separating the back cover.

    • Be cautious when opening the back cover as it is connected through fragile wires to the speaker.

  3. BU2cB1OoaXgfQdYp
    BU2cB1OoaXgfQdYp
    4jq2ttrQomQCTCAg
    f3enDjbADfNpXRZ6

    • Remove the speakers by using your hand to entirely disconnect the back cover.

  4. 5gsj1ayjD2GK36ef
    5gsj1ayjD2GK36ef
    3B3CPZLuyUZ4gQUZ

    • Carefully peel the tape holding down the wires connected to the speaker.

  5. uMu44CMfRbWitOts

    • In order to replace the speakers after they are removed, you must solder the wires back onto the motherboard.

    • The red wire must be soldered onto the "+" terminal while the black wire must be terminal must be soldered onto the "-" terminal.

    • Pull the speaker and wires from the motherboard.

    Where on the mother board do I sober the speaker wires ?

    bombom_buda07 -

    Where on the mother board do I sober the speaker wires

    bombom_buda07 -

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Thomas Lichtenberger

Member since: 21/01/15

459 Reputation

0 comments