Tineco FLOOR ONE S3 Breeze Wheels Replacement

Written By: Luke Guess
  • Comments: 0
Tineco FLOOR ONE S3 Breeze Wheels Replacement

Difficulty

Easy

Steps

5

Time Required

10 minutes

Introduction

The Tineco FLOOR ONE S3 Breeze (model no. FW007600US) will sometimes have problems with the wheels wearing out over time, and it may need to be replaced by removing the wheel cover plate and removing the existing wheels. After a quick reassembly the machine is ready to operate. This replacement guide contains the following steps for the wheels replacement.

The wheels are what allows the vacuum to move and clean efficiently. If the wheels are broken, then the vacuum is just about useless.

  1. JroOHMkU2OoAaoKq
    JroOHMkU2OoAaoKq
    kKtRcs1F2cJA2XSV

    • Place a finger on the lever located on the brush roller cover.

    • Firmly push the lever with a finger to remove the brush roller cover.

  2. MqTv2XmObWVXlSEB

    • Grasp the brush roller on its side.

    • Pull the brush roller out of its initial position.

  3. pmVMECpoNSQXuFs4
    pmVMECpoNSQXuFs4
    oaDksCDxQWGcvKBm

    • Remove four 10.6 mm screws from the plastic cover with a Phillips #1 screwdriver.

    • Remove the first plastic cover.

  4. YtKYLZCYjsMTCCOF
    YtKYLZCYjsMTCCOF
    ywm3riuAtXG2yuNa

    • Remove twelve 10.6 mm screws from the second plastic cover with a Phillips #1 screwdriver.

    • Remove the second plastic cover.

  5. j2eXTY2DiOMLmAlf
    j2eXTY2DiOMLmAlf
    Kcxub5JtZlZHSUBb

    • Remove two 10.6 mm screws holding the wheels in place with a Phillips #1 screwdriver.

    • Remove the wheels.

    • The wheels do not need to be removed to access the motor.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Luke Guess

Member since: 14/02/24

193 Reputation

0 comments