Texas Instruments TI-5130 Printer Unit Replacement

Written By: Shannon Perkins
  • Comments: 2
Texas Instruments TI-5130 Printer Unit Replacement

Difficulty

Moderate

Steps

5

Time Required

5 - 10 minutes

Introduction

Follow this guide to remove and replace the printing unit in the TI-5130 electronic calculator.

  1. a6A1hm5JqJYAR456
    a6A1hm5JqJYAR456
    Rd3to15qE1EEE6SU

    • Flip the calculator over and remove the 4 main 10mm screws with a PH1 screwdriver.

  2. HI6YajNuAWNKALOi

    • Flip the calculator back over and remove the top cover.

  3. BubO1rHkSoLcUrYV

    • Disconnect the printing unit from the motherboard by pulling up on the connector – located in the bottom left of the motherboard.

  4. JyrtWXZAffntkkxQ

    • Remove the ink cartridge by pushing the tab back then lifting it out to gain access to the screw that holds the printer in place.

  5. nOLrcWaWvRjsKNFv
    nOLrcWaWvRjsKNFv
    LOZaypJT1jVoVZiM

    • Using a PH1 screwdriver remove the 10mm screw that holds down the printer unit.

    • Remove the printer unit by lifting it up.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Shannon Perkins

Member since: 17/09/15

652 Reputation

2 comments

wehre did you buy the replacement printer

Tino ullrich -

what sources are there for TI-5130 printer unit?

Norman Todd -