Sony Cyber-shot DSC-W730 Control board Replacement

Written By: Douglas Howe
  • Comments: 0
Sony Cyber-shot DSC-W730 Control board Replacement

Difficulty

Easy

Steps

6

Time Required

15 minutes

Introduction

This could be a solution to the buttons on the back of the camera not working. This is an easy replacement. Just be careful with the ribbons.

  1. Y1IX5SBMJPiEmZ2C
    Y1IX5SBMJPiEmZ2C
    lKmERRIMmRdGvIOR
    MklhqKaFmTbTyZQn

    • Open the battery/memory card door and remove the 6 screws (.35cm) with a Philips 000 screwdriver. There will be two screws on the left and right sides, and two on the bottom.

  2. wp5MAQvUCHJioBqg
    wp5MAQvUCHJioBqg
    V6goUYYF2LoFwGJX
    IRF1m2W4wQdoUx2x

    • Take off the front part of the case with a plastic opening tool.

  3. owKMdugyXeJT2hU1
    owKMdugyXeJT2hU1
    iMcTM3uAHjktqKmH

    • Pull off the two silver side pieces on the left and right sides.

  4. TEtWsbibCQM1AFGV
    TEtWsbibCQM1AFGV
    f3qUeyXsAaBb4aCf

    • Remove the main back piece. It should easily lift off.

  5. xsbeeqFcAyhfHlZA
    xsbeeqFcAyhfHlZA
    KFThxPsWWSgDsXtC
    owTw6cV4WmGaVRWR

    • Unscrew the .45cm screw located on the upper right corner on the back of the camera. Once the screw is off, use the spudger and unclip the piece holding the top down on the upper left on the front of the camera. It should lift off with ease.

  6. SdhlY3YkrHwVE552
    SdhlY3YkrHwVE552
    BCHxc13F5ApSusdI

    • Flip over the control board then use tweezers to pull out the ribbon connecting the circuit board to the motherboard.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Douglas Howe

Member since: 08/01/15

510 Reputation

0 comments