Skullcandy Air Raid Speakers Replacement

Written By: Kristin

Comments: 2

Skullcandy Air Raid Speakers Replacement

Difficulty

Easy

Steps

9

Time Required

30 - 35 minutes

Introduction

This is a guide to replace your Skullcandy Air Raid's Speakers.

Tools

Step 1

LB2YK4AbsgNGkdJn

Starting with the corners, gently pull the rubber cover off of the device.

Step 2

jVDJetEZVeyIYHNA

Using the T-6 hexagonal screwdriver, unscrew the four 10mm #6 hex screws on the right side of the device.
Remove the handle from the device.

Step 3

pDPnwiNLYTQCRoIK

Unscrew the two screws on the left side of the device using the phillips #00 screwdriver.
One 5mm Phillips screw.
One 8mm Phillips screw.

Step 4

VbL3NTQQ6bEaJ3r6

Gently pull the sides of the front plate outwards from the device.
Pull up on the front plate to remove it from the device.

Step 5

1y2aXiZEVpjuEyaG

Using a #000 Phillips Screwdriver, unscrew the four 0.8 cm Philips screws from each corner of the speaker you are replacing (eight 0.8 Philips screws total).

Step 6

3PVupSAsISPMNXDv

Using the plastic opening tool, pry around edges of speaker to loosen glue contact with front plate.
If you are unable to loosen glue contact using the plastic opening tool, use a heat gun to assist in removal.

Please confirm the size of it's speakers.

Alberic Sungahid -

Step 7

NVDyOurEO3aP6JNW

Lift the speaker out of the device.
Be aware of the connection with the ribbon cable.
For reassembly, ensure proper orientation of the cable plug.

Step 8

k6Li5GeiUwPqtMRH

Firmly pull on the end of the ribbon cable to disconnect the speaker from the motherboard.

Step 9

SMWHNgLPdndqNux3

Desolder the black and red wires from the speaker.
The red wire is for the left speaker and the black is for the right speaker.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Kristin

Member since: 14/01/15

495 Reputation

One comment

Where can I buy the replacement speaker?

Luis Polino - 12/02/16