Skullcandy Air Raid Buttons Replacement

Written By: Sasha Nevin
  • Comments: 0
Skullcandy Air Raid Buttons Replacement

Difficulty

Easy

Steps

8

Time Required

20 - 25 minutes

Introduction

This disassembly includes the button panel and button motherboard.

  1. LB2YK4AbsgNGkdJn

    • Starting with the corners, gently pull the rubber cover off of the device.

  2. jVDJetEZVeyIYHNA

    • Using the T-6 hexagonal screwdriver, unscrew the four 10mm #6 hex screws on the right side of the device.

    • Remove the handle from the device.

  3. pDPnwiNLYTQCRoIK

    • Unscrew the two screws on the left side of the device using the phillips #00 screwdriver.

    • One 5mm Phillips screw.

    • One 8mm Phillips screw.

  4. VbL3NTQQ6bEaJ3r6

    • Gently pull the sides of the front plate outwards from the device.

    • Pull up on the front plate to remove it from the device.

  5. KdKVlBWFCUjyEkvA
    KdKVlBWFCUjyEkvA
    GkypsaRMeFeKFKmJ

    • Using a Phillips #00 Precision Screwdriver, unscrew two 6 mm screws from the middle of the panel, specifically above and below the volume buttons.

    • Lift the button panel.

  6. BTnMsN1dfqKGxBHh

    • Using a Phillips #00 Precision Screwdriver, unscrew two 6 mm screws from the button motherboard.

  7. CMPCvkgDnZuMAEjg

    • Using a plastic opening tool, pry up on the button motherboard to detach it from the device.

    • The button motherboard is connected to a ribbon cable inside the device.

  8. KuERDlbZOkGIc3Ql

    • First, pull on the black attachment to disconnect it from the metal piece.

    • Release the cable from the back of the motherboard.

    • The black attachment is a part of the connector, not the blue ribbon cable. It will not disconnect from the motherboard.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Sasha Nevin

Member since: 14/01/15

257 Reputation

0 comments