Sharp-EL-531xg Battery Replacement

Written By: Muhammad Hassan Majeed
  • Comments: 0
Sharp-EL-531xg Battery Replacement

Difficulty

Easy

Steps

7

Time Required

1 - 4 minutes

Introduction

This guide will show you how to replace the battery in a Sharp-EL-531xg calculator. You may need to change the battery when the calculator's display is dim or when the calculator is not working. This calculator has two ways to charge the battery: the solar cell and the battery; however, the solar cell is dependent on the battery.

  1. XF56RGARNvPwKX1k

    • Press the 2nd F button and then the OFF button to power down the calculator.

  2. k56VIEDupHAtbh5Z
    k56VIEDupHAtbh5Z
    1NNym1DvQZK3VHpo

    • Flip the calculator over so the back is facing upwards.

    • Remove the single screw from the battery panel using a Phillips #0 screwdriver.

  3. YiiShMcaZV6CKR46

    • Remove the battery cover using two fingers.

  4. smEuuODPDRKNhoAd
    smEuuODPDRKNhoAd
    JyOSvgiqCgruNsGr
    mW1bIj2WGP6Ttrvv

    • Place a spudger in the slot next to the battery and pry upwards to remove the battery.

    • Avoid using a sharp tool to remove the battery.

  5. fLZLVWxttrpjuoTJ

    • Place the new battery into the slot with the positive (+) side facing upwards

    • Don't press the battery too hard.

  6. jIKJrIGIQ1PjqwMJ

    • Put the battery cover back on.

    • Tighten the battery cover screw with a Phillips #0 screwdriver.

  7. ZNoQyHMSBoRRarax
    ZNoQyHMSBoRRarax
    FOjha3CEONOm2GeP

    • Press the On button to turn on the calculator.

    • Flip the calculator over so the bottom is facing upwards.

    • Press the reset button with the pointed end of a spudger to restart the calculator.

Author

Muhammad Hassan Majeed

Member since: 18/01/22

166 Reputation

0 comments