Shark Pet Perfect II Front Belt Replacement

Written By: Tanner Brown
  • Comments: 3
Shark Pet Perfect II Front Belt Replacement

Difficulty

Easy

Steps

4

Time Required

8 minutes

Introduction

Step by step guide on replacing the internal brush rotation belt. After removing a few screws, you can access the internal components of the motorized brush. After removing the belt, you should exercise care in handling the belt.

  1. NYHtxUfHYqceMMWL

    • Remove the motorized brush from the dust cup by pulling it apart.

  2. xeCfGXhipf51Nlej

    • Use a Phillips #1 screwdriver to remove the five 14mm screws from the face of the motorized brush.

    Thank you. Thank you. Thank you!!!

    john -

  3. wfUnOUJ6ZXUmlE3H
    wfUnOUJ6ZXUmlE3H
    wZg5EqGMjRhIXFVH

    • Separate the motorized brush face plate by using a flat prying tool.

  4. 1WbHba1F2HKICslg
    1WbHba1F2HKICslg
    oUKafSeWyJxk4jGJ
    FviRBManUUyjumrG

    • Remove the brush roller by lifting vertically away from the brush head. It should come out easily along with the belt.

    • Be careful in handling the belt. If stretched or damaged, the belt can cause the motorized brush to operate incorrectly.

    What if just the plastic gear is bad? Where can I find a replacement that will slip on and be attached properly. In many of these units that gear cracks with age, add do the end holders for the brush. I'm not sure where to obtain the proper gear, the number of teeth it has, the size of the gear, or the size of the hole. Help would be greatly appreciated as for a Ten cent part , SHARK ridiculously and very unjustly, wants me to buy a whole new unit for $50 plus shipping, but I can buy a brand-new one at Amazon for $48 . Still both are ridiculous for a $0.10 part. I have seen where I can get plastic gears but I am unsure of the size and how to attach it properly. The old one sweat and the motor spins freely inside the gear.

    F V -

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Tanner Brown

Member since: 27/06/17

459 Reputation

One comment

Thank you for this! I needed the picture to put it back together after I cleaned it out because it was not spinning. Working perfectly now! I also have an extra new battery if anyone needs it. :)

Aaron Woods -