Introduction
Prereq only guide to replace the freezer evaporator cover based on the Samsung RF28R7201SG refrigerator.
-
-
Use a flathead screwdriver to press in the plastic tab near the inner end of the drawer rail.
-
As you press the plastic tab, grasp the rail with your free hand and slide it towards you slightly to unlock the rail.
-
-
-
Repeat the rail unlock procedure on the other drawer rail.
-
Once both rails are unlocked, firmly pull both rails to slide them out of the refrigerator wall guides.
-
Remove the freezer drawer.
-
Push the geared torsion bar until it rests at the very end of the rails.
-
Align the drawer rails to the refrigerator wall guides.
-
Close the freezer drawer until the rails lock back in place.
-
-
-
Use your hands to lift the bottom edge of the evaporator cover up to release the lower plastic tabs.
-
Swing the evaporator cover upwards to access the connected wires behind it.
-
-
-
Use your fingers to squeeze and disconnect the fan cable connector from the back wall of the freezer.
-
To reassemble your device, follow these instructions in reverse order.
