Introduction

This replacement is needed when your phone's speaker is bad.

  1. Wjav2uKR6AOpKjln
    Wjav2uKR6AOpKjln
    X125VW26yDbWZCxQ
    WrYKIEgdxp25hpdT
    • Remove the back cover of phone by lifting up on the back cover tab with the blue plastic opening tool.

    • Go around the edge of the back cover to completely remove it.

    Thanks so much. I was getting seriously annoyed. This worked for me. However, I'll be getting another battery just in case. This helped big

    Ana -

  2. VoP44MWIaVFR5mkN
    VoP44MWIaVFR5mkN
    jbxkievERlNUqeaQ
    dOLtGXSvRZWynocF
    • Remove the old battery by lifting up on the thumb tab.

    • Periodically clean the brass terminals on the battery and the phone. Place a minute amount of ISO on a Q-tip and gingerly clean the connections.

  3. iMGBYGO6d2X6GoGQ
    iMGBYGO6d2X6GoGQ
    6QZtaHHKdSowjqO2
    TiTFaiQDYRYXlrAQ
    • Remove the nine 4mm screws screws from the midframe with a Phillips #000 screwdriver.

  4. nWgcMmZ5eMbHME6F
    nWgcMmZ5eMbHME6F
    nTcYHL1mMgYmAesL
    • Wedge the blue plastic opening tool in between the front and side panel.

    • Move the blue plastic opening tool around the edges between the front and side panel.

  5. P6fUhv1o6JeSIUje
    P6fUhv1o6JeSIUje
    ELRvJZTfajuDiCl2
    • Make sure that you detach the mid-frame from the inside too.

  6. RXjQZvhtTXveJRJl
    RXjQZvhtTXveJRJl
    Iv13Ve3BupukmGYO
    • Use the plastic opening tool to unhook the ribbon cable clip.

  7. I2dwSVJRvFZpY26U
    I2dwSVJRvFZpY26U
    CmYNM31TZHCBxXyE
    • Gently pull on the connector with the tweezers until the speaker comes off.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Kyle Ruff

Member since: 04/02/16

6749 Reputation

0 comments