Introduction
You will be removing the battery from your device. If you haven't done so already, make sure the tablet is completely powered off before continuing.
Tools
-
-
Remove the stylus from the device.
-
Place the device screen-up on a hard surface, like a table.
-
-
-
Insert a plastic pry tool or opening pick between the glass and plastic case.
-
Work your way around the plastic edge, unclipping the backplate.
-
Once the clips are loosened, remove the backplate. Some force may be necessary.
-
-
-
Disconnect the three ribbon cables from the motherboard to free the battery.
-
Use your finger to lift the flap securing each ZIF connector.
-
Slide the ribbon cable out and towards you. Now it should be completely detached.
-
Repeat with the other two cables.
-
-
-
Get a firm hold of the power cable as close to the clip as you can.
-
Pull the power cable up and out of the clip.
-
-
-
Remove the six 3.5-mm screws using the Phillips #00 screwdriver.
-
Lift the battery out by hooking your finger under the tab on the top side of the battery and pulling it up and towards you. The battery should come out easily.
-
To reassemble your device, follow these instructions in reverse order.
5 comments
Thanks! Now i won't screw it up asm's destroy expensive technology like i normally do fumbling my way through these types of things!
lynz318 -
Awesome! Thanks for this! I managed to replace the battery, but it still won't power on. It was water damaged a while back. Any ideas on next component to try replacing?
joeshuer -
Do you have a battery for the Samsung ATIV Smart PC 700T1C?