Ryobi RJ1861V Assembly Bar Bearing Replacement

Written By: Morgan Doyle
  • Comments: 1
Ryobi RJ1861V Assembly Bar Bearing Replacement

Difficulty

Moderate

Steps

10

Time Required

No estimate

Introduction

  1. LEHPKoDNSTUXayVV

    • Use a Torx T5 screwdriver to remove the single 8 mm screw securing the shoe.

  2. SXn4QdKkiJMOKW2K
    SXn4QdKkiJMOKW2K
    AQFdX2f1YrpKQEZl

    • Remove the rubber sleeve.

    • You may have to use some force as it has a tight fit.

  3. wudpn1SWV2ZQDoV5

    • Use a Torx T5 screwdriver to remove the six screws on the underside of the device.

  4. VqrvDlSUhOoSFfQL

    • Use a Torx T5 screwdriver to remove the four screws on the top of the gear case.

    • There are two screws on each side of the device.

  5. qmeuqKYmCq2yI5Ff

    • Remove the backside panel.

  6. BEbOjI3g1NoHFqRK

    • Unscrew the four T5 Torx screws that hold the assembly bar in place.

  7. qZA3D3WJBtyyggAE

    • Lift the assembly bar up and out of the chassis.

  8. ROgaKHrqbNDc2plG

    • Begin with the top of the device facing up.

  9. wZZpkZepbY41F3fD

    • Insert needle nose pliers to remove the retaining pin at the top of the bearing.

  10. BETDyKqqCWjEmXtw

    • Once the retaining pin has been removed, pull off the damaged bearing and insert a new one.

    where can I buy the new bearing, please?

    George -

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Morgan Doyle

Member since: 08/04/19

316 Reputation

0 comments