Ricoh Shotmaster 130Z Zooming Lens Replacement

Written By: anna carolina von einem
  • Comments: 0
Ricoh Shotmaster 130Z Zooming Lens Replacement

Difficulty

Moderate

Steps

6

Time Required

5 - 15 minutes

Introduction

If the zooming lens of your Ricoh Shotmaster 130Z camera is broken or malfunctioning, this guide will show you how to replace it step-by-step.

  1. cwlZAFHHGeJPJrQs

    • Set the dials to "A" (Auto), and Off mode.

    • You will not be able to move these dials once the case has been opened.

  2. 22nOPsRgvhpjOeQx
    22nOPsRgvhpjOeQx
    h6upLmrdbIHDFcow
    bNWurgPXiUGYnRpK

    • Remove the 5 Phillips screws from the sides and the back.

  3. PZZR4mT5BnQKVPQo
    PZZR4mT5BnQKVPQo
    EVl1RcWYtU6hO3m2

    • Remove the 5mm JIS #00 screws from the bottom of the camera.

    • Pay attention to the 6mm screws on the sides of the tripod slot, as they are a slightly different size from the rest of the screws. However, you still may use a J00 screwdriver to remove them.

  4. Ol3KYtS1rqO1ehfy
    Ol3KYtS1rqO1ehfy
    u1lu15IIBTOEuFhH

    • Using an opening tool, lift the case of the tripod slot (on the bottom) until the back portion of the case is released.

    • Continue to use the the opening tool to insert it and lift right next to the strap of the camera.

    • This will release the front portion of the case.

  5. jehBNLDBAAPtE1sY
    jehBNLDBAAPtE1sY
    ZqKZEFUTGtMGJU1Y
    qHItXL2JvSYKyfVA

    • Use a JIS #0 screwdriver to remove the three marked screws found around the perimeter of the lens.

  6. cYFhNTeD6mAoUlNs
    cYFhNTeD6mAoUlNs
    P5GSJ6jFnsst4roI
    RyQkBYSSmYDv6PgC

    • Proceed to remove the two screws using a JIS #00 screwdriver.

    • Use tweezers to lift the lens off of the board.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

anna carolina von einem

Member since: 19/10/16

450 Reputation

0 comments