Revlon RVIR1008 Barrel Shell Replacement

Written By: Cassidy Madrigal
  • Comments: 0
Revlon RVIR1008 Barrel Shell Replacement

Difficulty

Easy

Steps

7

Time Required

5 minutes

Introduction

  1. JEXBj1Fe5GahMH2M

    • Place curling iron on a flat surface along with required tools and barrel shell replacement.

    • Curling iron is extremely hot after use. Carefully unplug and let device sit and cool to room temperature before proceeding.

  2. DcEUdNuLMTP2BWNq

    • Using both hands, carefully detach both ends of the metal stand from the body of the iron by pulling away from the barrel.

  3. dRSYLSs2rOLThRqF
    dRSYLSs2rOLThRqF
    mZaVM1oFnmjBRxoF

    • Unscrew the 3mm screws from both sides of the barrel clip with a 3.0 flathead screwdriver to remove the clip from the barrel.

    • Set the two screws and barrel clip aside for reassembly.

    • Clip is prone to pop off from the body due to the weight of the spring. To prevent this, equally loosen each screw little by little.

  4. 61rJ6ATAVFD32jH4
    61rJ6ATAVFD32jH4
    MRBTxfJxTnOQLVWM

    • Squeeze both sides of the barrel clip spring and slide the component away from the barrel to remove.

    • Slowly decompress the spring after removal from the spring plate to avoid any hazards.

  5. Y1g64f1qETdWPpxc
    Y1g64f1qETdWPpxc
    U6XfA5KUj14BGfp3

    • Remove 3mm screw holding the metal spring plate in place with the 3.0 flathead screwdriver.

    • Place the screw and plate to the side for later reassembly.

    • Removing the screw allows for removal of the barrel from the iron itself. Be sure not to pull the barrel.

  6. GwgFri5Ijh6ViWkN
    GwgFri5Ijh6ViWkN
    xpMVpXKGPMrMtiMm
    Z2GQ4vonsPSET1tE

    • Remove the two screws holding the plastic casing together using the 3.0 flathead screwdriver.

    • Remove the front plastic cover from the main body.

    • The plastic cover contains warnings and is located on the devices handle.

    • Once completed, the internal parts of the iron will be exposed.

    • Place the two screws and plastic cover to the side for later reassembly.

  7. hHBm5BR13BuvgNnI

    • Remove the cylindrical barrel shell by sliding it away from the devices main heating element. wisdom here.

    • Retrieve replacement barrel shell and slide it onto the devices main heating element.

    • Be careful to grip the device firmly and precisely to avoid stripping away the internal components underneath the handle.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Cassidy Madrigal

Member since: 11/04/17

113 Reputation

0 comments