Introduction

Before you can start on this repair, you have to open up the machine. Please use the guide for a plastic frame model or the one for a metal frame model.

These instructions may also help with other Saeco models and with coffee makers from Philips and Gaggia—they are all made by the same manufacturer and have a very similar design.

  1. PNr1AAlHSHeeiWkI
    PNr1AAlHSHeeiWkI
    KArcyvLOVQRTMyvf
    • First check which model you have in front of you: is the decorative frame made of chromed metal (image 1) or made of metalized plastic (image 2). In the first case use this guide, in the second case use this guide. Then come back here.

    • Also make sure that the power plug is unplugged.

  2. mm1pDY2eNTihewBJ
    mm1pDY2eNTihewBJ
    lkBxMYf2PFN14twV
    • If the support plate for the exchangeable bean container has already been removed, you can skip this step.

    • The carrier plate is attached with five Torx T10 screws. turn them out.

    • Lift the carrier plate up and place it on the device.

    • Don't lift the plate all the way out yet. It is still connected to a sensor cable. The cable does not necessarily have to be detached.

  3. nSSeXhliMXs2FAUx
    nSSeXhliMXs2FAUx
    IbXVCvomEYnDjMfi
    • The instantaneous water heater is now clearly visible. It is still hidden under a gray plastic cover. The cover is attached with two latches. The one on the back is a bit difficult to access.

    • Press down on the tabs with your finger and lift off the cover.

  4. sxrwo1sUgqA2ttv2
    sxrwo1sUgqA2ttv2
    SZMWO1ISLUS2PyBh
    • The holder of the instantaneous water heater is fastened with three Torx T10 screws. (The third is here covered by the heater). remove those.

    • The heater is attached to the support plate with a Torx T20 screw. remove that one.

  5. iWRuyaW6Ltk1EBkf
    iWRuyaW6Ltk1EBkf
    rAytPVrEZsLbXCwK
    • The Oetiker clamps on the hose connections must be cut open with side cutters.

    • Then pull off the hoses.

  6. Hd5TL4GCqTfUhiKg
    • Remove the Phillips #2 screw on the thermal switch holder.

    • Lift off the holder and thermal switches.

    • Disconnect the spade connectors on the heater connections.

    • Apply thermal paste to the replacement part and attach the holder and thermal switches.

    • Plug in the flat plugs for the heater.

  7. a3AbidSbdRaBEUVJ
    a3AbidSbdRaBEUVJ
    WSetDEGJO5HEXOsf
    • When reassembling, the Oetiker clamps can be replaced with a 9mm hose clamp.

Conclusion

Follow the steps in reverse order to reassemble your device.

VauWeh

Member since: 19/10/15

219661 Reputation

One comment

es gibt auch noch auf der unterseite des Erhitzers einen Thermosensor, der ebenfalls entfernt und mit Wärmeleitpaste an dem Austauschteil befestigt werden muss

Hermann Floerchinger -