Removing the Solenoid Replacement

Written By: Shane Villalpando
  • Comments: 1
Removing the Solenoid Replacement

Difficulty

Easy

Steps

4

Time Required

5 minutes

Introduction

  1. 25NjWjUYjjQkb2Ft

    • Gently use tweezers to detach the white vision wire harness, located directly under the feed tube.

    • Another small tool or your fingers will work for this.

  2. Nd15JTrWVugfLZVY

    • Remove the two 1-1/4" screws on either side of the circuit board using a 3/32" allen wrench.

  3. dumZ6Ed1PKIvnDwl

    • Separate the solenoid from the gun's body by gently pulling it upwards.

    What do I do if the forward screw broke off on the blue air hose. Where can I get a new screw?

    Imaki2018 - -

  4. QAdgQdmjDVuDaECR

    • Slide the metal body out of the plastic shell by holding one in each hand and gently pulling apart.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Shane Villalpando

Member since: 02/02/15

1031 Reputation

0 comments