Removing Philips DC320 37 Bottom Panel

Written By: Greg Lane
  • Comments: 0
Removing Philips DC320 37 Bottom Panel

Difficulty

Easy

Steps

4

Time Required

5 - 15 minutes

Introduction

Welcome to the DC320 Repair Guide, your comprehensive resource for restoring power and performance to your electronic device. Whether you're a seasoned technician or a DIY enthusiast, this guide will walk you through the steps to address common issues and revitalize your DC320.

  1. OJE6iwTF1MfAQKG6

    • Pry off the four white feet with the pointed end of the spudger

  2. V21CawLi2fTRLHrQ

    • Gently unscrew the four 15.5 mm Phillips #2 screws that hold the bottom panel to the dock.

  3. EVAJNaADthnDRWtk

    • Use the flat end of the spudger to pry the lid off from the two connectors holding it to the body of the dock.

    • The connectors on the panel are fragile and may break.

  4. AC4yGkktpFkIrau5
    AC4yGkktpFkIrau5
    4OAFMGFY6edvpdQ6
    CTAQrEGNPjMJkIUY

    • Carefully pull up and out the four electrical connectors and two ribbon connectors that connect the bottom panel to the dock.

    • Electrical Connectors

    • Ribbon Connectors

    • The cables do not have a lot of slack in them. Be careful not to break the connectors.

    • One wire is soldered onto the bottom panel. Be careful not to break this bond.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Greg Lane

Member since: 16/04/13

39 Reputation

0 comments