Removing Audio Technica ATH-AD500 Foam Disks

Written By: Melanie Reis
  • Comments: 2
Removing Audio Technica ATH-AD500 Foam Disks

Difficulty

Easy

Steps

4

Time Required

5 minutes

Introduction

This installation guide will help you with the following:

  • removing foam disk
  • decreasing the bass

  1. rpS5JvUHYDupqrjD

    • Remove the ear pads by peeling them away from the grill.

    My jbl waerless headphone speaker changes how price

    Max Mad -

    How to install the earpads

    rangaranju -

  2. e1ykEWrDhPKcE66K

    • Remove all four 1cm screws on the inside of the headphone using a #1 Phillips head.

  3. RITkRvUmZxWKwhZh

    • Remove the speaker from the grill by pulling it out.

    • Remove the speaker carefully so you do not rip the wires out.

  4. ATBWS113nUosMpsT
    ATBWS113nUosMpsT
    1bsqDk4iD3M6YrIA

    • Remove the foam disk from the grill by peeling it away from the grill.

    • During reassembly, make sure that the speaker is angled into your ear canal.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Melanie Reis

Member since: 11/01/13

227 Reputation

0 comments