Introduction

Use this guide to replace the USB port of the RCA Lyra X2400.

  1. drO36gfGoaPUWbBr
    drO36gfGoaPUWbBr
    dFrHjRoeqpKfJi3v
    • Remove the two Phillips screws from the silver cover at the top of the Lyra.

    • Slowly wiggle the silver cover while pulling it away from the device.

  2. mSWjogCEjHZNEsFV
    mSWjogCEjHZNEsFV
    NaYDx5uAWXQWNVSG
    • Remove the two Phillips screws from the bottom of the device, next to the charger port and Compact Flash release button.

    • Pull the silver case from the bottom of the device.

  3. PnVlGHOmxSNbGQGO
    PnVlGHOmxSNbGQGO
    3sWE4AsA61vymGr5
    sigmxLubsUfmNuXM
    • Carefully pry up the screen with a plastic opening tool.

    • Disconnect the screen's ribbon cable from the circuit board.

    • Remove the screen.

  4. XArOcxUANAqSXP4L
    XArOcxUANAqSXP4L
    PlL5Beh5D2qXcdCe
    • Open the case of the Lyra.

    • Remove the four screws that secure the motherboard to the frame of the Lyra X2400.

  5. DdPyb5NxXDRH1BIZ
    DdPyb5NxXDRH1BIZ
    ZxK2fULBLW5WkcU2
    • Locate the USB in/out component on your Lyra X2400. If you are having difficulty locating this component the picture to the left will show you where it is located.

    • Start using solder/desolder tools to remove the USB in/out.

    • Once removed replace it with the new working USB in/out.

    • Use the soldering tools to reattach the component back to the main logic board.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Joseph Goodwin

Member since: 11/04/13

1 Reputation

0 comments