Prep Black Wire

Written By: Russell Frampton
  • Comments: 0
Prep Black Wire

Difficulty

Easy

Steps

6

Time Required

5 minutes

Introduction

How to prep a black wire for XYZ job.

  1. QlXNwHFWXMIxX1jE

    • Locate QCPN#10669 which is a black hookup wire.

  2. JiInjIXcDayloHmG
    JiInjIXcDayloHmG
    fMjIKUoBMOC5ZHnM
    YIPGxMgQRT2FXbLr

    • Measure out a 10cm length of wire.

    • Use a pair of flash cutters to carefully cut through the wire.

    • Caution: the wire must be no longer than 10.5cm and no shorter than 9.5cm in length.

  3. HLcFCTHykVE41CMP

    • Your wire should look like this now. #testedit

  4. tb5oZncjPMOyxDuQ
    tb5oZncjPMOyxDuQ
    VrfSXAshhqIh2IaJ

    • Measure 20mm from either end of the wire.

    • With the flash cutters remove the instulation that is covering the wire.

    • Be careful not to cut to deep because you will damage the wire strands inside.

  5. QV2cxRTBJWTOTCri
    QV2cxRTBJWTOTCri
    sgiMfwaVddZhCPqZ

    • Measure 10mm from the other side of the wire.

    • Remove the insulation from the wire with a pair of flash cutters.

  6. VXNgG1luIKUEuRXr

    • Your finished wire should now look like this.

    • Remember to twist of the ends of the wire with your fingers so that the wire strands are not loose.

Conclusion

You are finished.

Author

Russell Frampton

Member since: 31/07/13

356 Reputation

0 comments