Introduction
Use this guide to replace the speakers on your Polaroid A10.
-
-
Begin by having the side with volume and power button face up towards you.
-
Insert a plastic opening tool between the display and the back cover.
-
Once you have one plastic opening tool in, you can insert another one. While holding one in place, slide the other along the gap to release the tabs.
-
-
-
The speakers are located on the bottom of the device, below the battery and adjacent to the motherboard.
-
-
-
Using the Phillips #000 screwdriver, remove the two 7 mm screws located in the picture by rotating the screw counter-clockwise.
-
Carefully remove the speakers from original position without pulling out the wires.
-
-
-
Using the soldering tool, remove the two small black wires and two small red wires from the motherboard.
-
The wire connections are located on the motherboard next to the corner of the battery closest to the motherboard.
-
To reassemble your device, follow these instructions in reverse order.
3 comments
This is not what I meant I wanted to know what to do if the wires came out of the
If the wires and out of the
Speaker right