Introduction

A unique aspect of this BiPAP device is its attached built-in humidifier. However, when this feature isn’t working properly, the device is ineffective and your comfort can significantly decline.

The humidifier feature should be checked every few months to ensure that it is working properly. The following guide details how to take all of these parts apart and replace them if they are malfunctioning.

For more information on replacing the humidifier, please refer to page 7-2 in the service manual.

  1. PHoqxp44UZ4HEvu1
    • Remove the Water Chamber Assembly.

    • Gently squeeze the latch on the Flip Lid Assembly to release it.

    • Lift the Flip Lid Assembly.

    • Pull the Humidifier Tank Assembly out of the Humidifier.

  2. CWQFXKmSErgpOtFa
    • Remove the Tank Top Seal from the Flip Lid Assembly.

    • If this is the source of the error, put in a new one.

  3. UqpWtvHIUKeqk4Oh
    UqpWtvHIUKeqk4Oh
    xGbAuw4OtQLoGpQW
    • Remove the Dry Box Seal.

    • If this is the source of error, place this part with a new one.

    • When replacing, ensure that the narrow end of the seal is inserted into the Dry Box.

  4. RtLFXfjmXusr2xYU
    RtLFXfjmXusr2xYU
    6cQZELTOS1AFAvbn
    • Remove the Dry Box Assembly.

    • Insert a flat blade screwdriver into the hole located on the back of the Humidifier and lightly press inward to release the Dry Box Assembly.

    • Do not press firmly on the screwdriver as damage may occur.

    • Remove the Inlet Seal from the Dry Box Assembly

  5. WL62sesApD6XUIXX
    WL62sesApD6XUIXX
    m23d4uGvyBBFZb2I
    xbYldy5omYAJZPmo
    • Remove the Flip Lid Assembly.

    • Use a screwdriver to push in on the latches that secure the Flip Lid Assembly to the Humidifier Top Housing.

    • Bend the Flip Lid Assembly completely backwards until it is removed.

    • For Heated Tube devices, remove the wire harness from the base.

  6. Ii1QPJK2mnPwLkUg
    • Use a T8 Torx screwdriver to remove the four #4 x 1/2" screws that secure the Top Housing to the Humidifier Bottom Housing

  7. GajtokJqROOiILla
    • Slide the Outside Cover out of the Bottom Housing.

  8. 6Pmx4LPBL5VFHZ6m
    • Remove the Left Side Panel.

    • Use a T15 Torx screwdriver to remove the four #6 x 1/4" screws that secure the Bottom Housing to the Lower Base Assembly.

  9. PQQRXK3vGCB14B1B
    PQQRXK3vGCB14B1B
    yOWCjhKWdT4pqfLF
    • Remove the Heater Plate Assembly.

    • The Heater Plate Assembly is secured by two small tabs.

    • Once replaced, secure the Bottom Housing to the Lower Base using the four #6 x 1/4" screws.

    • Be sure the Heater Plate Spring is properly seated under the Heater Plate.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Courtney Huitt

Member since: 08/04/20

169 Reputation

0 comments