Introduction

This guide provides the steps to remove the back cover. This process is necessary to access many of the components inside.

  1. Q1LlhVrXXRipQNLs
    • Locate the bay door for the battery on the left side of the laptop.

  2. h6mfbF2ZDfEn4bdR
    h6mfbF2ZDfEn4bdR
    HLsS2NIP2NZDIW1r
    • Slide the latch to the right and then down to unlock it.

    • Pull out the battery.

  3. FSQbvcfPXo12LNEW
    • Flip the device upside down with the handle facing away from you.

    • Open the optical drive bay by sliding its latch to the right.

    • Locate optical drive release mechanism on the bottom of the laptop.

  4. igiZjJEo3xfOBr5H
    • Slide the latch cover to the right.

  5. ZA6hifMQSLb1YJVx
    ZA6hifMQSLb1YJVx
    ZyKxqZGFUDbb6uOx
    • Push the exposed switch to the left to eject the optical drive.

  6. LQAoluGSYIBSVyYH
    • Begin by turning the laptop upside down with the handle towards you.

    • Use a Phillips size 0 screwdriver to remove the 4 screws holding down the ram cover.

  7. YNShuNVRHD2kgTMB
    • Remove the panel and set it aside.

    • Use a Phillips size 0 screwdriver to remove these 8 small screws.

  8. olTmDAePCCWkaBTC
    • Use a Phillips size 1 screwdriver to remove the remaining 8 screws.

  9. PoSREVQ5ThVquIdH
    PoSREVQ5ThVquIdH
    Lbuy1HBVxRyhL2LB
    • Use a plastic opening tool to release, but NOT remove, the back cover because it is sealed with adhesive.

  10. UYMZNkmSyQr5IqNA
    • Be careful when lifting the cover as you may damage some connections.

    • Slowly lift the cover so that you can disconnect the red and white wires connecting the speaker to the sound card.

  11. ULLZQiETLcSKPdi3
    • Now the back cover should be off and you can access the inside of the casing.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Rohun Heesen

Member since: 13/04/10

426 Reputation

One comment

thanks for this crucial tuatorial >

Joe Gutierrez -