Introduction

  1. RHXhMsEMpsIUFFHY
    • Remove protective flap by pulling directly out from the top.

    • The two clips will pop out

  2. iRQNTTx1SbB1c5cP
    • Remove Faceplate. There is a tab where the finger is located in the picture that needs to be pulled up.

    • The Faceplate will then easily lift off.

  3. IDKnZtnVOoUJyn6f
    IDKnZtnVOoUJyn6f
    MLuiLB3E2VEYr42O
    • Using a a T5 Torx bit screwdriver, remove the four screws located on the back of the device turning counter clockwise.

    • The link to purchase this screwdriver is Located here.

  4. XjCStNdxNZ5FoWqA
    • This is what the device looks like once you have taken the screws out and opened the device.

  5. oe5PXoNfS6CBSvYZ
    • The Motherboard and screen will pop out of the back case easily.

    • Be careful when doing this step, the components are fragile.

  6. dtYtuLuFuNUdat4W
    • To remove the screen from the motherboard there are going to be three tabs that need to pulled up.

    • ** This step needs to be done with special care because it is very fragile.**

    • Once they are all three popped up the motherboard and screen will separate easily.

  7. 2JY5IXEMps5TvZFb
    • Click here for Palm m105 screen replacement

    • Now that the screen and motherboard are separated you may discard the broken screen. The best way to dispose of the broken screen is to: Recycle it

Conclusion

To reassemble your device, follow these instructions in reverse order.

Erik Thompson

Member since: 04/10/11

31 Reputation

0 comments