Introduction

The buttons may get stuck or broken with use. This guide will show how to remove the buttons in order to properly replace them.

  1. fESYlVnCF16Oxiwi
    • Remove the bread pan.

  2. J4QOxeqOBA221FZ4
    J4QOxeqOBA221FZ4
    UVWGT245LglAIHVY
    aOaIuHkoyVyFvnHa
    • Remove the eight 22mm Phillips #1 screws from the grey lining.

    • Remove the grey liner.

  3. cvQcKh6t55HpeeGv
    cvQcKh6t55HpeeGv
    4pcUiknXH3B2RPxI
    • Remove the two 11mm Phillips #1 screws from the back of the device.

  4. PoQILLhnSPXKduoi
    PoQILLhnSPXKduoi
    tMgqjkftjjvEZtrU
    • Pop off the top case using a spudger.

    • Keep the spudger away from the control panel.

    • Be aware of wires connecting the microcontroller to the panel when removing the top lining.

  5. AmQ1GOxrVMfaXYwF
    AmQ1GOxrVMfaXYwF
    gSMYOdKE4qAEut4f
    e4Lfd3a5u4igRZoy
    • Disconnect microcontroller and top lining.

    • Ground yourself prior to disconnecting in order to avoid harming the inner electronics.

  6. CkHVBL6WTOSjVaRh
    CkHVBL6WTOSjVaRh
    bBPOZALJ11QBh5tO
    • Remove the two 11mm Phillips #1 screws from the top cover.

  7. xO52lVwBKhXsawVE
    • Use spudger to pop the control panel out.

  8. TNngh2sJmXiZavbK
    TNngh2sJmXiZavbK
    JegdOJcIlW25CTsb
    UwHWMCet5gOMn3cV
    • Remove the four 11mm Phillips #1 screws from the control panel.

  9. aENwv2acRlTrkPt2
    aENwv2acRlTrkPt2
    FWS6aAT6YhNGyYaW
    VbSkTvdWJ1tmCjVr
    • Remove the two 11mm Phillips #1 screws from the button panel.

    • Flip the screen assembly over and remove the button panel.

  10. iOpJpolxxSyvTTli
    iOpJpolxxSyvTTli
    RZHTLOhtqYEjPbTr
    • Remove and replace buttons as necessary.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Megan Saunders

Member since: 25/01/18

701 Reputation

0 comments