Introduction
You will need to replace the battery in your controller if it is not holding a charge or your controller is not turning on. When taking apart the controller, be careful as the buttons are not held in place by anything and can easily fall out.
-
-
Use the angled tweezers to remove the vibration motor cable, moving it upward from its socket.
-
Lift the vibration motor out of the front case.
-
Repeat for the other side.
-
Use the angled tweezers to remove the battery cable, moving it upward from its socket.
-
-
-
Using the T6 Torx screwdriver, remove the indicated eight screws from the logic board.
-
Lift the logic board away from the front case.
-
-
-
Using the T6 Torx screwdriver, remove the indicated four screws from the panel.
-
Remove the panel from the front case.
-
Lift the battery from the front case to remove it.
-
To reassemble your device, follow these instructions in reverse order.
8 comments
Where can i buy the replacement Battery? What tags should i use to find it?
LC18650 Remote Control accu