NuVision TM800A510L Charging Port Replacement

Written By: Kelsey Riggs
  • Comments: 0
NuVision TM800A510L Charging Port Replacement

Difficulty

Difficult

Steps

4

Time Required

1 - 3 hours

Introduction

Your time will be split between removing the back from the device and de-soldering. The charging port itself is actually soldered onto the bottom of the motherboard. To access it, it is best to remove the motherboard from the device.

  1. XgiipNgPNUSQPe2W
    XgiipNgPNUSQPe2W
    MDU4bQLHLuCV4Ik6

    • Use a Heat Gun to loosen the adhesive on the underside of the back cover.

    • Use some prying tools to lift the back cover off of the device.

    • I recommend heating up the device up to 'just barely too hot to touch' and then prying sides up one at a time.

    • Although, you can use either plastic or metal prying tools, metal prying tools may scratch the device. Make sure not to damage power and volume buttons when prying the cover off as well.

  2. DpJa5OIsMiMS26Vn

    • Unscrew the motherboard.

  3. N2aD566n34DWLr3W

    • Make sure all ribbons are disconnected.

  4. DTfIFsHcTAwmfHXt
    DTfIFsHcTAwmfHXt
    Mbm1D2BCMRYyrXlv

    • Desolder the Motherboard- this will make it easier to get to the charging port without breaking any cords.

    • Flip the Motherboard over and desolder the charging port from Motherboard.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Kelsey Riggs

Member since: 25/01/17

486 Reputation

0 comments