NPET K10V3 USB Cable Replacement

Written By: Matthew Costa
  • Comments: 0
NPET K10V3 USB Cable Replacement

Difficulty

Easy

Steps

3

Time Required

5 - 10 minutes

Introduction

This guide gives detailed instructions on how to replace the NPET K10V3 USB cable. If you are having trouble with your keyboard being unresponsive or losing connection, follow this detailed guide on how to remove the current cable.

Hazards:

  • Electric shock
  • Sharp objects

Special Requirements:

  • Disconnect keyboard from power source
  • Clean workspace
  • Careful removal to prevent risk of damaging delicate parts

  1. GolFFhoMTwOE4Mhr

    • Flip the keyboard over so the bottom is facing upwards.

    • Remove five 4.5 mm screws using a Phillips #2 screwdriver.

    • Remove three 9 mm screws using a Phillips #2 screwdriver.

  2. kjXCZpg5kOOHbGZQ

    • Remove the kickstand from the keyboard.

  3. oBUqhi6trVnh4HXK
    oBUqhi6trVnh4HXK
    qx5RSLDTgWY4MQa5
    OL3KADXErOFRbHX3

    • Remove the COM2 connection from its housing with a set of tweezers.

    • Do not pull by the wires; only pull by the plastic housing.

    • Remove the USB cable from the device.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Matthew Costa

Member since: 18/03/24

343 Reputation

0 comments