Introduction

You will start by following the guide to remove the bottom case of the lapdock. After doing this you will remove the screws from the trackpad frame and gain access to the trackpad itself. Then you will unplug the trackpad from the motherboard. Once all of this is done you will be able to remove the trackpad from the lapdock.

  1. 5PvipkXcMe6ENPFU
    5PvipkXcMe6ENPFU
    Kdi5pXUlhhB324s1
    • To take off the Keyboard there are three tabs at the top of the Keyboard in the locations shown in the picture that you must press and unclip. They are located behind each of the keys that are removed.

    • You do not need to remove any keys to unclip the keyboard. We did this for picture purposes only.

  2. QhqRBeDkQkEvxaIX
    • You can use a small metal spudger to depress each tab to avoid scratching the keyboard.

  3. tuw6fGIIdPi4O2Yh
    • Lift up keyboard so that you are able to see the ribbon cable connected to the contact.

  4. yX2JWtcTQRXCCyPI
    yX2JWtcTQRXCCyPI
    kSAA6DEYHKPdCJfT
    • Flip up the ZIF connector holding the ribbon cable on the contact as shown in the two pictures and then gently disconnect the ribbon cable.

  5. fsWDMSwuCb2DGSCB
    fsWDMSwuCb2DGSCB
    bB1rIEGqsIrLKgTT
    • After we remove the Keyboard, you can clearly see the screws under it. Remove the ten 3mm long phillips head screws.

  6. BNHkyyXBpSkxycrb
    BNHkyyXBpSkxycrb
    VgTVTVDpJSADGBDJ
    RMN62Xrt4XYWlpnQ
    • Flip over the Lapdock and remove the four 3.5mm long phillips head screws from the bottom.

  7. pb62fIBYJQagcgOL
    pb62fIBYJQagcgOL
    MjAydsuxOpbAaxcx
    • Use a plastic prying tool to take off the bottom case. Make sure that all of the clips are unclipped before trying to remove the case.

  8. NrnRl6IUfPsUnucR
    NrnRl6IUfPsUnucR
    bi4CQ5JRsbYsnHga
    • Remove the five 1.2mm long screws with the PH0 screwdriver from track pad reinforcement frame.

  9. HZiglr6CswSoBWwI
    HZiglr6CswSoBWwI
    cynHAIvRmA6HFsUe
    TurIRS1TYkLVestC
    • Unplug track pad from the ribbon cable that is attaching it to the motherboard then use a plastic prying tool to take out the track-pad.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Anthony Aiumu

Member since: 12/01/16

770 Reputation

0 comments