Mk Diamond Wet Saws MK660 2010 Blade Cover Replacement

Written By: Carsten Frauenheim
  • Comments: 0
Mk Diamond Wet Saws MK660 2010 Blade Cover Replacement

Difficulty

Moderate

Steps

5

Time Required

No estimate

Introduction

How to remove the cutting head's blade cover for replacement or further device service for the Mk Diamond Wet Saw MK660 2010.

  1. 1PxeDQYqBQ233hrw
    1PxeDQYqBQ233hrw
    IRyQRqTroDdkvOdI
    MdZQD1eHaLdr53Fb

    • Before you begin, make sure to power off and unplug the device from the outlet.

    • If the clear water pump hose is connected, remove it now.

    • Loosen the plastic knob holding the saw's cutting head in place.

    • Lower the cutting head while keeping it steady.

  2. tGXO5ZwpfDMQqleL
    tGXO5ZwpfDMQqleL
    nJuiajrrOlNUASWL

    • Unscrew the knob.

    • Remove it from the cutting head.

  3. qqmPylZjmBpUSer1
    qqmPylZjmBpUSer1
    D2vbW4t5NvitZ1r2

    • Loosen the plastic knob holding the blade cover in place.

  4. GeVKq3xu1LCI4Du2
    GeVKq3xu1LCI4Du2
    DbWeQbHwT1KeG1Ie
    2PiWwbLoYillPmVG

    • Loosen the wing nut on the blade cover pivot shaft.

    • Remove the wing nut and accompanying washer.

  5. fPx4CnQEso32iGJU
    fPx4CnQEso32iGJU
    IZZQ5RAsvjexgUmO

    • Pivot the blade cover up and pull it off the shaft.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Carsten Frauenheim

Member since: 10/03/20

124524 Reputation

0 comments