Microsoft Surface Pro 7 Kickstand Replacement

Written By: Sam Omiotek
  • Comments: 3
Microsoft Surface Pro 7 Kickstand Replacement

Difficulty

Easy

Steps

4

Time Required

5 - 10 minutes

Introduction

Follow this guide to replace the kickstand on your Microsoft Surface Pro 7.

Some photos in this guide are from a different model and may contain slight visual discrepancies, but they won't affect the guide procedure.

  1. l6CxkeRCYCfps41y
    l6CxkeRCYCfps41y
    QpTcp5MstgYRwKNR
    4gdaqdEPadLSuVZp

    • Lift the kickstand to expose the hinge screws.

  2. Bwrd2rN16FKtjPlK
    Bwrd2rN16FKtjPlK
    tVki4SRBvnMQOaNF

    • Remove the four 2.7 mm T3 screws—two on each side of the kickstand.

  3. YgPcNRDOWFF6uQBy
    YgPcNRDOWFF6uQBy
    JKYAk3SgYC4OQDbY
    KFSSDXajFbtN2w4T

    • Move the kickstand back down to a flat position.

    • The hinges are stiff and you may need to use some force to get it down.

  4. 5N2y4DJJiTLOuPnU
    5N2y4DJJiTLOuPnU
    lTSWKST4Mt5OvBbC
    6D6DwE4flZrYF5Zi

    • Remove the kickstand from the back cover.

    • There are two adhesive tabs in the middle of the kickstand that disengage most easily when the kickstand is pulled directly downward from the device.

    • Be sure to insert these tabs when reinstalling the new kickstand before replacing the screws.

    Heute selbst durchgeführt. Hilfreich wäre, die Beschreibung um folgende Info zu ergänzen: wie man die Scharniere nach Schritt 4 wieder aus den Einbuchtungen im Gehäuse hochgestellt bekommt, um das neue Kickstand zu montieren. Nach eigenen Überlegungen konnte ich die Schaniere durch Einführen des benutzten Torx-Schraubenziehers in die äußere Schraubenbohrung des Scharniers und ganz behutsamen Hochdrücken des Scharniers mit Hilfe des Schraubenziehers lösen.

    Oliver Bendig -

Conclusion

To reassemble your device, follow the above steps in reverse order.

Take your e-waste to an R2 or e-Stewards certified recycler.

Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers community for help.

Author

Sam Omiotek

Member since: 25/02/19

78491 Reputation

2 comments

One of the hinges broke on my Surface Pro 6.

1. I removed the broken hinge, closed the kickstand and duct taped the seam.

2. I opened the kickstand wide and duct taped the seam.

The single hinge and duct tape seem to be working!

"Spare the duct tape, spoil the job." - Red Green

P Best -

What are the parts used for this fix?

Andrea Shaw -