MerchSource the Black Series Boat Racer Gaskets Replacement

Written By: Monica Reece
  • Comments: 0
MerchSource the Black Series Boat Racer Gaskets Replacement

Difficulty

Moderate

Steps

4

Time Required

5 minutes

Introduction

This repair guide will show you how to replace the gaskets in the MerchSource the Black Series Boat Racers toy boat. The gaskets are foam pieces that secure the battery compartment in the boat from water leakage.

  1. 6Z3RDT6NCr21bvGB
    6Z3RDT6NCr21bvGB
    O2pmfeDNwghUAclO

    • Remove the screw on the top of the boat at the rear end using a Phillips #2 screwdriver.

    • Screw length is 16 mm.

  2. pWP2AZpMjVCx1yMJ
    pWP2AZpMjVCx1yMJ
    IiHGTQpyxcEOguMv
    2BLYmCX52AVZyg2o

    • Remove the top of the boat by sliding it backwards and then pulling it off.

  3. XQW34p5gklSprNnk
    XQW34p5gklSprNnk
    Uq45BIh6SPfrOPhD

    • Grab the rubber gasket with tweezers and pull it out of the slot.

  4. 3GshjeySMmQ3BVmp
    3GshjeySMmQ3BVmp
    ePHSeZDhfreHDVZW
    4EKtQMRfbTgLL5ki

    • Gently remove the gasket and replace with a new one.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Monica Reece

Member since: 31/08/18

672 Reputation

0 comments