Magellan RoadMate 5236T-LM Back Cover Replacement

Written By: Megan Scribner
  • Comments: 0
Magellan RoadMate 5236T-LM Back Cover Replacement

Difficulty

Easy

Steps

3

Time Required

2 - 6 minutes

Introduction

Cracked plastic casing? This guide will help you replace the back cover of the Magellan RoadMate 5236T-LM.

  1. p2fF6Z6I5gHaGWoR
    p2fF6Z6I5gHaGWoR
    p5SJqpwLcfsvPik3
    1Svd4JYdw3Gl3NbI

    • Place the device face down on a flat surface.

    • Remove the four 5mm screws at each corner using a #000 Phillips head screwdriver.

  2. GaUOpC3rlbOnjf2b
    GaUOpC3rlbOnjf2b
    CTJRMcflo2LXUCts
    gUFIjGIYg2VfYJAT

    • Gently wedge a plastic opening tool into the seam along the side of the device.

    • Slide the tool along the seam to pry apart the front and back covers.

  3. 1rd5RA2vFEO1OObv
    1rd5RA2vFEO1OObv
    3Nigqqyih35W5Yiw

    • A ribbon cable attaches the display screen and the motherboard via a ZIF connector. Remove the tape covering where the ZIF connector connects to the mother board.

    • Use tweezers to disconnect the ZIF connector from the motherboard.

    • The ZIF connector may disconnect itself from the motherboard when removing the tape.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Megan Scribner

Member since: 19/10/16

315 Reputation

0 comments