MSI GP60 2PE Leopard Wireless Card Replacement

Written By: Zoey Calcagno
  • Comments: 1
MSI GP60 2PE Leopard Wireless Card Replacement

Difficulty

Moderate

Steps

11

Time Required

5 - 10 minutes

Introduction

Is your wireless card not working? Here's a guide to replace it. Make sure you follow each step accordingly and carefully replace the wireless card.

  1. Y5dL1hgpDPbcUSEJ

    • Flip MSI GP60 2PE Leopard, so that the back is facing up.

  2. dqB1oD1OUl2qM6DZ

    • Find the unlock tab located on the upper right side of the device, then slide it to the right.

  3. ZGXgv4VFa2KmyYGj
    ZGXgv4VFa2KmyYGj
    2Hqa3qhVEpWYyq5X
    CMNK1FgmLomllQO1

    • Slide and hold the release tab on the left side of the battery, so that you can remove the battery.

  4. 5hHK5fPTnVpbyn3a
    5hHK5fPTnVpbyn3a
    ggf5ppJF4OlvAGMC
    iVTbRyQ6YjMfoNSU

    • While holding the release tab, remove the battery slowly.

  5. BHrjFcDVNAHFRYnq

    • Flip the device over so the back is facing up.

  6. MUKFAf2iAxnOfQWb
    MUKFAf2iAxnOfQWb
    TYx5wGngoTVHxlji

    • Remove the four 5mm screws from the back of the device using a Phillips #00 screwdriver.

    • There is a screw located under the battery; lift the battery up to access it.

  7. YrDhMToIpVrFaInS
    YrDhMToIpVrFaInS
    BXjZtOmQCicMTM5o

    • Once all four screws are removed, lift the back off.

  8. O4ME5AjXQpqdiaFQ

    • Locate the wireless card.

  9. dFjYcntsSruYeYRM

    • Using a Phillips #00 screwdriver, remove the one 2 mm screw that is holding the wireless card in place.

  10. aySLyvQNQDoR2uwY

    • Carefully remove the wireless card.

    • Pay close attention to the two wires attached to wireless card.

  11. POXlNLwSeNWXoTeB
    POXlNLwSeNWXoTeB
    bVVXsDRY5sG1ZDJH

    • Remove the wires connecting to the wireless card by pinching around the base where they connect, then carefully disconnect them.

    • The wires should come off fairly easily.

    • Avoid yanking or pulling too hard. This can result in the wires breaking.

    Can I replace the card with a 5g card? If so, what card do I need.

    Andrew Goodall -

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Zoey Calcagno

Member since: 04/10/18

672 Reputation

0 comments